Activity

Bad thermal paste is one of the most common causes of Xbox overheating and the red ring of death. This can happen if the glue is improperly applied during fabrication of this console. Bad paste may also result from exposure to heat over lengthy time periods. As the paste slowly breaks down, you will start to encounter an overheating problem that gradually dissipates over time. If the glue fails quickly, this will cause an almost instant two reddish light error in minutes of turning on your Xbox.

Whether you should attempt to replace the thermal paste in your own is dependent upon whether or not you want to make use of your warranty. If you’ve never opened your console before, then using your guarantee to get the problem fixed by Microsoft is the very best alternative. Just remember that once you do start the console, your warranty will be voided.

liquid metal thermal paste helps if you comprehend why you are doing something, so bit of theory will be discussed. When the paste breaks , it functions as a barrier to heat as opposed to a bridge. This means the heat sink will not be able to do its job of drawing heat from the GPU.

1.) After the heat sink was removed from the motherboard, always clean off the old paste. Implementing new paste on top of the old does not do anything since the old glue will block appropriate heat transfer. The old glue can be removed by employing rubbing alcohol using a sterile cloth. The surface ought to be shiny when you’re finished. It is pointless to wash only one of the two mating surfaces. After cleansing, never touch the surfaces with your fingers because this may leave oil in the shape of a finger print.

2.) Consistently use the paste in a thin coating. The thinner it’s, the better it will operate. Just be certain that the whole surface is covered. You will learn this when you can not see any of the shiny metal. A good rule of thumb would be to apply a dab of paste about the size of a BB.

3.) This also gives you more control than trying to do this with a stick.

4.) Arctic silver 5, a top quality thermal paste, is recommended.

5.) Before you start the console, disconnect it from its power source. Keep all liquids away from the work area and never do your job on a carpet. Carpeting can cause static electricity that will damage the motherboard parts.